Sikafloor®-2350 ESD
Sikafloor®-2350 ESD is a two-component, electrostatic dissipative (ESD) epoxy floor coating with self-smoothing properties. It provides a smooth, glossy, durable, abrasion-resistant, and seamless surface that is easy to maintain. The product can also be incorporated into slip-resistant flooring systems. It is suitable for interior applications on concrete and cementitious substrates.
Sikafloor®-2350 ESD Applications
The product can be used as:
A smooth roller-applied floor coating
A smooth wearing course
A seal coat or topcoat for slip-resistant broadcast flooring systems
A textured or structured surface finish
An electrostatic dissipative (ESD) flooring system for interior areas
Suitable for the following substrates:
Concrete floors
Cementitious floors or cement-based substrates
The product must be applied by experienced contractors or trained professionals and is intended for interior applications only.
Key Features of Sikafloor®-2350 ESD
Helps dissipate and control electrostatic charges
Low VOC emissions
Low odor during application
Good abrasion resistance
High mechanical resistance
Provides a smooth, glossy, and seamless surface
Easy to clean and maintain
Can be applied as a smooth or slip-resistant surface
100% solids content by both weight and volume
Mixing Method
For the A+B system:
Stir Part A until the pigments are uniformly dispersed.
Add Part B.
Mix for approximately 3 minutes.
Transfer the mixture into another container and mix again.
Scrape the sides and bottom of the container to ensure thorough mixing.
For systems containing aggregates, gradually add the filler/quartz while mixing Components A+B, then continue mixing for approximately 2 minutes.
Precautions
If heating equipment is required, do not use gas, oil, or paraffin heaters, as they produce large amounts of CO₂ and water vapor. Electric hot-air blowers should be used instead.
Before installing the complete flooring system, a Reference Area should be prepared for inspection and approval by all relevant parties.
High temperatures combined with high point loads may cause indentations in the floor surface.
Direct sunlight may cause discoloration; however, according to the product documentation, this does not affect the performance of the flooring system.
