Sika AnchorFix®-1 Fast-Curing Anchoring Adhesive for Reinforcing Steel

Used for anchoring reinforcing steel and bolts in general applications with light to medium loads
Fast curing
Compatible with standard sealant guns, with no shrinkage during drying and curing
Excellent adhesion to concrete and other materials
Suitable for anchoring reinforcing steel with diameters of 8–27 mm
Solvent-free formulation, making it odorless
Non-shrink and non-sagging, even in overhead applications

Product Description

Sika AnchorFix®-1 is a two-component, solvent-free and styrene-free polyester anchoring adhesive designed for structural bonding and anchoring applications.

Features / Benefits

Fast curing
Can be applied using standard sealant guns
Suitable for application at low temperatures
High load-bearing capacity
ETA approved for anchoring in uncracked concrete
ETA approved for anchoring in solid and hollow masonry
Non-sagging, even in overhead applications
Styrene-free
Low odor
Minimizes material waste during application

Applications

Used as a fast-curing chemical anchoring adhesive for bonding and anchoring various materials, including:

Rebars / Reinforcing Steel
Threaded Rods
Bolts and Special Fastening Systems

Suitable Substrates

Concrete
Hollow and solid masonry
Hard natural stone*
Solid rock*

Note: Substrate properties may vary significantly, particularly in terms of strength, composition, and porosity. Therefore, before application, the suitability of Sika AnchorFix®-1 should be tested on a sample area, with particular attention to bond strength, surface staining, and potential surface discoloration.

Sustainability

Sika AnchorFix®-1 complies with LEED v2009 IEQc 4.1 requirements under the Low Emitting Materials category for Adhesives and Sealants, including architectural applications and multipurpose construction adhesives.

Approvals / Standards

– CE marking and Declaration of Performance for bonded injection-type anchors used in uncracked concrete in accordance with EAD 330499-00-0601, based on ETA-13/0720 dated 18/05/2018, together with a Certificate of Constancy of Performance for the construction product issued by a designated product certification body.

– CE marking and Declaration of Performance for injection-type anchors used in masonry applications in accordance with ETAG 029, 2013 edition, used as a European Assessment Document (EAD), based on ETA 17/0179 dated 27/02/2017, together with a Certificate of Constancy of Performance for the construction product issued by a designated product certification body.